240V outlet installation cost
A new 240-volt circuit and outlet, for an EV charger, dryer, welder or range, run from your panel. Typical total for the default job: $701 (range $377–$1,467).
| Line item | Low | Typical | High |
|---|---|---|---|
| Wire and conduit | $60 | $85 | $120 |
| Double-pole breaker, outlet, box | $40 | $70 | $150 |
| Electrician labor (3.3 h at $106/h) | $152 | $346 | $797 |
| Permit | $50 | $100 | $250 |
| Service call / trip charge | $75 | $100 | $150 |
| Total | $377 | $701 | $1,467 |
What drives the price
- Distance from the panel and how hard the wire route is
- Amperage (wire gets thicker and pricier at 50 A)
- Permit and inspection fees
- Whether your panel has room and capacity (a panel upgrade costs thousands)
- GFCI breakers required in garages and outdoors in many codes
How this estimate is built
Equipment and material lines use typical retail prices for the item, checked against current listings. Labor is hours for this scope (our estimate, shown in each line) times a billed hourly rate: the national median wage for the trade from the U.S. Bureau of Labor Statistics, times 3.5 to cover what a contractor pays on top of wages (payroll taxes, insurance, vehicle, licensing, unbilled time) and profit, adjusted for your area. The low and high columns use cheaper or pricier equipment, fewer or more hours, and billing multiples of 2.5× and 5×. More on the method.
What people reported paying
Real quotes and bills people shared online. Each scope is different, so use them as a sense of range, not a benchmark.
- $886 paid: 240V EV outlet next to the breaker box, permit included (Antelope, CA) (thread)
- $775–$950 quoted range for a 240V outlet with a double-pole GFCI breaker (Round Rock, TX) (thread)
Questions
How much does 240v outlet installation cost?
For the default job below, about $701, with a range of $377 to $1,467 depending on equipment, access and local labor rates. Change the inputs to match your job.
Do I need a permit for a 240V outlet?
Most cities require a permit and inspection for a new circuit. Licensed electricians usually pull it; the fee is often $50 to $250.
Sources
Other calculators: Water softener · Garage door · Garage door opener · Gutters · Gutter guards · Toilet · Sump pump · Garbage disposal · Recessed lighting